ELECTRIC START SYSTEM DEALER SET-UP INSTRUCTIONS for
SNAPPER LARGE FRAME SNOW THROWERS
INTRODUCTION: It will be necessary to complete Dealer Set-Up Instruction #2-8224 first before attempting to
install the electrical components described in this Electric Start System Dealer Set-Up Instruction.
WARNING: Always disconnect spark plug wire from spark plug before performing maintenance on snow
thrower. DO NOT operate snow thrower without guards in place. DO NOT put hands into areas that house
rotating parts while machine is in operation!
STEP 1: Drill two 5/16 diameter holes in right side of
auger housing using dimensions shown. See Figure 1.
LIGHT
5/16 DIAMETER
HOLES
AUGER
HOUSING
TIE
LIGHT WIRE
HARNESS
3-7/16”
4”
4-5/16”
TIE
FIGURE 1
STEP 2: Drill two 5/16 diameter holes in control panel
within the 5” by 7” boundary lines shown. Drill holes
using dimensions shown. See Figure 2.
FIGURE 3
STEP 4: Remove battery mounting bracket and battery
clamp from #6-0651 Battery Mounting Kit and assemble
these parts as shown. See Figure 4.
BOUNDARY
LINES
BATTERY CLAMP
CONTROL
PANEL
BATTERY MOUNTING
BRACKET
5”
5-3/4”
7”
5/16 DIAMETER
HOLES
BEND TAB OVER
FIGURE 2
FIGURE 4
STEP 3: Install light onto control panel with washer and
nut and tighten securely. Install light wire harness into
end of light wire and route down handle and secure with
ties as shown. See Figure 3.
INSTRUCTION #2-9693 (I.R. 8/94)
|
Sennheiser Stereo Receiver EM 1005 90 User Manual
Sharp All in One Printer TINSE4377FCZZ User Manual
Sharper Image Thermostat OQ234 User Manual
Silva Boating Equipment 70p User Manual
Singer Sewing Machine 11W8 User Manual
Sony Cell Phone D5102 D5103 D5106 User Manual
Sony Clock Radio ICFCD3iPSIL User Manual
Sony Speaker XS V6933 User Manual
Sony TV Video Accessories HMZT3W User Manual
Sunbeam Espresso Maker EM3600 User Manual